need files
-
- B Poster
- Posts: 21
- Joined: Wed Mar 04, 2015 3:55 am
need files
Can anyone give me, or direct me, to some files to cut out silhouette stencils. My machine (Silhouette Cameo) can import .studio, .gsd, .dxf, .png, .jpg, .jpeg, .gif, .tif, .tiff, and .bmp. I have found some things but it just ain't right 100%.
Thanks a bunch
Thanks a bunch
Steven
Benton Gun Club, Arkansas
Benton Gun Club, Arkansas
- acorneau
- AAA Poster
- Posts: 880
- Joined: Sun Feb 22, 2015 12:12 pm
- Location: Houston
Re: need files
This thread on RFC might give you a few leads...
http://www.rimfirecentral.com/forums/sh ... p?t=595229
http://www.rimfirecentral.com/forums/sh ... p?t=595229
Allen Corneau
-
- B Poster
- Posts: 21
- Joined: Wed Mar 04, 2015 3:55 am
Re: need files
Ok, that did not work so I went to work. Several hours later I have workable files for my Cameo.
Steven
Benton Gun Club, Arkansas
Benton Gun Club, Arkansas
-
- B Poster
- Posts: 21
- Joined: Wed Mar 04, 2015 3:55 am
Re: need files
Ended up scanning free .pdf targets to a .tif. open the .tif and use the trace tool. Rams were a lot of work to get the hole for the horns.
Steven
Benton Gun Club, Arkansas
Benton Gun Club, Arkansas
- ShootingStar
- AA Poster
- Posts: 395
- Joined: Sun Apr 19, 2009 2:47 pm
- Location: Asheville, NC
- Contact:
Re: need files
Hey wherdthatunhit,
I sent you a PM with dxf files of the smallbore animals. Don't know how often you check pm's.
ShootingStar
I sent you a PM with dxf files of the smallbore animals. Don't know how often you check pm's.
ShootingStar
-
- B Poster
- Posts: 21
- Joined: Wed Mar 04, 2015 3:55 am
Re: need files
Thank you ShootingStar. I got busy and forgot all about it, but again, thank you. I was over in Knoxville this summer and almost had some time off to go to a match or two. i was going to go to Asheville or Chattanooga. Might still get there some time. Did you see the picture of my cup I posted?
Steven
Benton Gun Club, Arkansas
Benton Gun Club, Arkansas