Dumb question
-
- A Poster
- Posts: 152
- Joined: Mon Feb 01, 2016 7:25 pm
Dumb question
My CZ 455 has a short length of pull for me. Was going to add a button plate from a flip flop, but can't get the stock plastic one off! I resorted to prying with a knife, but I gouged the wood. Any thoughts? I'm almost ready to put a grinder to it. Like its glues on.
Thanks
Chuck
Thanks
Chuck
-
- A Poster
- Posts: 127
- Joined: Tue Jun 06, 2006 9:36 pm
- Location: Corpus Christi, TX
Re: Dumb question
A heat gun might work. If you don't have one, borrow your wife's hair dryer. Don't tell her.
- DavidABQ
- Expert Master Poster
- Posts: 1819
- Joined: Mon Jul 27, 2009 9:33 pm
Re: Dumb question
The CZ butt plates typically come off with a hear gun.
-
- A Poster
- Posts: 152
- Joined: Mon Feb 01, 2016 7:25 pm
Re: Dumb question
Thanks guys, hair dryer did the trick! extra 3/4" pull makes a nice difference.
-
- AAA Poster
- Posts: 630
- Joined: Thu Aug 08, 2013 9:18 pm
Re: Dumb question
There are two screws also holding on the butte late, make sure those are out too. I shortened the pull for my fiance's rifle, I had to saw through those lol.