Page 1 of 1

Flat/Straight Trigger

Posted: Thu Mar 30, 2017 5:58 pm
by jloehle
Anyone know of a place to buy a flat/straight trigger for the Anschutz 1712?

Joe

Re: Flat/Straight Trigger

Posted: Fri Mar 31, 2017 8:06 am
by Bob259
jloehle wrote:Anyone know of a place to buy a flat/straight trigger for the Anschutz 1712?

Joe
Call Mark Pharr (Tumbleweed Custom 512-246-7563), he used to have them

Re: Flat/Straight Trigger

Posted: Fri Mar 31, 2017 6:42 pm
by sdwooster
I have some trigger shoes for the 1712. private message me and I will try to send you a picture. The cost $25

Steve

Re: Flat/Straight Trigger

Posted: Fri Mar 31, 2017 9:33 pm
by sdwooster
100_1463.jpg
100_1464.jpg
I figured out how to put picture on this, I hope. I have two styles, one has a little more texture and the other is smoother. Both can be sanded to the texture you like. These are made out of metal with a 3d printer. Have many out in use for a long time.

Steve

Re: Flat/Straight Trigger

Posted: Sat Apr 01, 2017 7:30 pm
by DavidABQ
If this will fit inside a OEM Anschutz trigger guard I am getting one. I have short fingers so it needs to go pretty far back. I don't like the OEM trigger, too narrow for my tastes; I like a wide trigger.
\m/

Re: Flat/Straight Trigger

Posted: Mon Apr 17, 2017 12:27 pm
by jloehle
Anyone have an email for Mr Wooster above? I have sent 2 PMs through the forums with no response. I am sure he just doesn’t see them.

Re: Flat/Straight Trigger

Posted: Mon Apr 17, 2017 12:42 pm
by Jason
jloehle wrote:Anyone have an email for Mr Wooster above? I have sent 2 PMs through the forums with no response. I am sure he just doesn’t see them.
His email address is sdwooster (at) msn (dot) com and he usually replies pretty quickly. He might be kinda busy right now, though. He's the match director of the Conard Bernhardt Cup match that is happening in less than two weeks. I hope to see most of the people on this forum there!