cz Bottom metal?
- silhouette13
- AA Poster
- Posts: 489
- Joined: Sun Dec 04, 2005 12:08 pm
- Location: Amherst NH
cz Bottom metal?
morning folks,
there used to be a site to get bottom metal fro a 452 it is now closed, is there any source for decent looking metal? berhaps i should snag a pc of aluminim and a fils and make my own?
david
there used to be a site to get bottom metal fro a 452 it is now closed, is there any source for decent looking metal? berhaps i should snag a pc of aluminim and a fils and make my own?
david
Sako Finnfire /weaver v16 tk lee 3/8 dot
Hoyt
Truball
Easton
Hoyt
Truball
Easton
-
- B Poster
- Posts: 59
- Joined: Fri Jan 06, 2006 9:55 am
Re: cz Bottom metal?
Might try here. Did not see any on main site but found this under blems;
http://www.diproductsinc.com/Detail.asp ... 1&CAT=3606
http://www.diproductsinc.com/Detail.asp ... 1&CAT=3606
-
- B Poster
- Posts: 37
- Joined: Wed Oct 27, 2010 7:05 pm
- Location: Houston, TX
Re: cz Bottom metal?
David,
I've bought factory bottom metal directly from cz-USA. You just have to call them. 800 955 4486
I've bought factory bottom metal directly from cz-USA. You just have to call them. 800 955 4486
-
- Unclassified Poster
- Posts: 3
- Joined: Wed Feb 11, 2009 10:15 pm
- Location: E. WA
Re: cz Bottom metal?
silhouette13 wrote:morning folks,
there used to be a site to get bottom metal fro a 452 it is now closed, is there any source for decent looking metal?...
How about this?
Or my latest: Blind Magazine(proto-type)
- BCloninger
- Master Poster
- Posts: 1331
- Joined: Mon Feb 15, 2010 11:22 am
- Location: Fort Smith, Arkansas
Re: cz Bottom metal?
Hot Rod, it's about time you wandered over to this corner of the net!
"You are never too old to set another goal or to dream a new dream."
- C.S. Lewis
- C.S. Lewis
-
- Unclassified Poster
- Posts: 3
- Joined: Wed Feb 11, 2009 10:15 pm
- Location: E. WA
Re: cz Bottom metal?
BCloninger wrote:Hot Rod, it's about time you wandered over to this corner of the net!
Been here for a while(almost 2yrs) but was not able to post. Kept getting an error message so I found a work-a-round.