More expensive to feed, but worth it.
5 posts • Page 1 of 1
The rule states that the bottom of the scope tube can be no higher than 1.5 inches from the top of the action. It occurred to me while looking at a Remington 700 action that the front receiver ring is higher then the rear receiver Bridge. So where would this one and a half inch measurements be taken from? The front receiver ring or the lowest part on the top of the receiver? Maybe Ms. Jeanine can weigh in on how that would be ruled on. Thank you
I shot silhouette since 1972. I retired master class in Hunter class. I used the weaver see through 1 piece rings. Never had them move, they are super light. And we're just the right height for me. I have several sets for Rem. 700, I would sell for $15.00 plus shipping. They are 1.035" high. Thanks. Tom 307-349-1578 for info.
Who is online
Users browsing this forum: No registered users and 3 guests