FORMING BRASS
FORMING BRASS
fellow silhouette shooters I would like to know how you form 260rem brass from 243 lapua brass. I just got a bad batch of rem brand brass.The lapua brass should be more uniform I need to know the correct way of forming the brass to 260 THANK YOU
Anthony G
Anthony G
-
- AA Poster
- Posts: 287
- Joined: Mon Nov 28, 2005 10:41 pm
- Location: Texas
Contact me @ e27122002@yahoo.com
Maybe I can help.
Maybe I can help.
- stsbuyer
- AAA Poster
- Posts: 514
- Joined: Fri Nov 18, 2005 6:53 am
- Location: Alvin, TX
260 from 243
Rambuster, you are going to need a tapered expander. You should be able to find them available form most of the major reloading die manufacturers. It will replace the one in your 260 die and will make it were you can neck up the 243 brass.
Good luck,
Paul
Good luck,
Paul
Anthony,
I replaced the standard expander plug on my Redding .260 full-length dies with a TAPERED EXPANDER plug.
Using RCBS lube and a Q-tip, I swabbed the inside of the lapua .243 case necks, just inside the case mouth. I then applied lube to the entire outside of the cases and ran them through the FL die. No problems.
Make sure you ream and chamfer the expanded case mouths after cleaing the cases.
Joaquin
I replaced the standard expander plug on my Redding .260 full-length dies with a TAPERED EXPANDER plug.
Using RCBS lube and a Q-tip, I swabbed the inside of the lapua .243 case necks, just inside the case mouth. I then applied lube to the entire outside of the cases and ran them through the FL die. No problems.
Make sure you ream and chamfer the expanded case mouths after cleaing the cases.
Joaquin