SOLD

Hello,

I'm looking to sell this trimmer.

I got it from an older gentleman that was getting out of shooting. It looks to be used, although not much, but not abused. It does have 2 nicks by the case holder that I'm not sure from what??? You can see in the pics.

It has 2 shell holders #4 & #10
Also has 22, 24, 25, 27, 28, 30, 35, 44 and 45 pilots

$165 TYD, Paypal Friends or add the 3% for Goods and services

I have the same one except I bought the universal spring loaded shell holder and a new carbide bit. Works fantastic. GLWS.

That’s a great piece of equipment.
I have many extras of those shell plates if anyone needs them.
Although kind of expensive,the 3 way cutters are a blessing in time saving.Not so much if you don’t dedicate one to each caliber.

I have the rcbs case prep station next to it on the bench and go with a routine of trim, outside chamfer, inside chamfer, neck brush, primer pocket brush, retrim and measure. I found that doing the outside then inside chamfer grows the brass a couple thousands and I try to hold +/- .0005. The 3 way cutters are nice but limited to the one diameter per head, I am cheap by nature....

Anyone who has been trimming brass by hand and needs to do a bunch at one sitting (100+) this thing is a wrist savor...