Weaver Bases for 1712?

mordecai · Post by **mordecai** » Fri Jun 08, 2007 9:49 pm

Can I assume the Weaver Bases for all of Anschutz 54 models fit the 1712? Brownells lists a lot of 64 and 54 models, but nothing in the 17xx range.

genphideaux · Post by **genphideaux** » Sat Jun 09, 2007 5:49 am

mordecai,

1712 is a 54 action, a 1416 is a 64 action.

mordecai · Post by **mordecai** » Sat Jun 09, 2007 5:10 pm

So are all "54" actions drilled and tapped the same on current rifles?

genphideaux · Post by **genphideaux** » Sat Jun 09, 2007 5:36 pm

As far as I know, from all my reasearch. Take a measurement with a micrometer and call the brownell tech dudes.

Good luck.

Bob259 · Post by **Bob259** » Sun Jun 10, 2007 7:29 am

mordecai wrote:So are all "54" actions drilled and tapped the same on current rifles?

The Weaver one's I used were the Weaver #91's on my 1712 and 54.18. I believe they fit both the 54 and 64 actions if I read the package correctly.

carl425 · Post by **carl425** » Tue Jul 24, 2007 8:51 am

I'm using the Weaver bases on my 1712 (forget which ones). I've found that the rear base mounts too far forward on the receiver to be able to get the scope back as far as I'd like.

Jason · Post by **Jason** » Tue Jul 24, 2007 9:37 am

I tried those Weaver bases on my 1712 but they didn't give me nearly as much range of mounting the rings as dovetail mounts, so I went back to my BKLs and haven't looked back.