Merrier scope base question

All the dope on risers, rings, scopes and optics.
Post Reply
22's forever
B Poster
B Poster
Posts: 32
Joined: Sat Mar 12, 2011 4:28 pm

Merrier scope base question

Post by 22's forever »

I have a set of Merreir scope bases that I'm borrowing to make a set of my own. When I measure the front base it has a taper of .015" from back to front. The aft end of front base is .955 and the front is .940....is this built in for MOA ? The rear base is .970 all the way accros. So before I start to make these I wanted to make sure if the taper is really supposed to be there? Or if I should make them the same hieght ? Any help on this would be great.
Thanx again
chickenchoker
A Poster
A Poster
Posts: 123
Joined: Thu Nov 08, 2007 6:10 pm

Re: Merrier scope base question

Post by chickenchoker »

The taper is intentional.
Post Reply