Half Size Target Files
-
- B Poster
- Posts: 61
- Joined: Tue Jan 24, 2012 5:43 am
Half Size Target Files
I am looking for files that can be used by a C&C machine to cut out 1/2 size targets for our new Smallbore Cowboy Match. I thought I had seen files posted somewhere before, but am only seeing a couple of PDFs around that are not vector files and would not work.
I would also look at any company that has them ready to sell, as well. I am afraid of shipping costs with that, but worth a look.
Thanks,
Joe Loehle
I would also look at any company that has them ready to sell, as well. I am afraid of shipping costs with that, but worth a look.
Thanks,
Joe Loehle
- Tlee
- AAA Poster
- Posts: 679
- Joined: Wed Feb 21, 2007 9:55 am
- Location: Where Bob Wills is still the King
- Contact:
Re: Half Size Target Files
I have PDFs, but they're bitmap/non-vector.jloehle wrote:I am looking for files that can be used by a C&C machine to cut out 1/2 size targets for our new Smallbore Cowboy Match. I thought I had seen files posted somewhere before, but am only seeing a couple of PDFs around that are not vector files and would not work.
I would also look at any company that has them ready to sell, as well. I am afraid of shipping costs with that, but worth a look.
Thanks,
Joe Loehle
They most reasonable place I've found for targets is based in Dallas:
http://custommfgco.com/targets/
Need to give them some reasonable lead time for a quantity as they don't keep a large number in inventory.
- Tim
- ShootingStar
- AA Poster
- Posts: 396
- Joined: Sun Apr 19, 2009 2:47 pm
- Location: Asheville, NC
- Contact:
Re: Half Size Target Files
Joe,
I have AutoCAD files that I'll send you.
It will take me a day or two - is that OK?
Also, they do not have bases drawn, just the animal figure.
Only so much 1 fellow can do in a day!
ShootingStar
Greg
I have AutoCAD files that I'll send you.
It will take me a day or two - is that OK?
Also, they do not have bases drawn, just the animal figure.
Only so much 1 fellow can do in a day!
ShootingStar
Greg
- Another Dang 9
- Master Poster
- Posts: 1333
- Joined: Thu Dec 10, 2009 7:24 pm
- Location: The Peoples Republic of Massachusetts
Re: Half Size Target Files
Joe. There's more to it than that. You need someone with a plasma cutter. Most weld shops will have them. You also need to have the PDF files converted to a DFX file. That's what the plasma cutter reads when it makes the cuts. What state are you in? Shipping steel is ridiculously expensive. If you go to a weld shop and buy Hot Rolled or Cold Rolled steel its much much much cheaper than AR type steel. I could help more. Send me a pm with a phone number with a good time to call and ill call ya back.
Its a dog eat dog world and I'm wearing milk bone underwear.
NRA Endowment Member
NRA Endowment Member