Winchester 9422 trigger job

Centerfires, rimfires, pistol cartridges and everything in between.
Post Reply
Joaquin B
AA Poster
AA Poster
Posts: 270
Joined: Sat Aug 12, 2006 11:26 am
Location: Oro Valley, Arizona

Winchester 9422 trigger job

Post by Joaquin B »

I was fortunate enough to pick up a pristine, unfired Winchester 9422. However the rifle would benefit from a trigger job, since the trigger is awfully creepy.

Can anyone recommend someone who can work a the trigger on this rifle to competition-level?

As usual any advice is greatly appreciated in advance!
Joaquin B
CamP
A Poster
A Poster
Posts: 145
Joined: Mon Nov 09, 2015 7:48 pm
Location: Fort Worth

Re: Winchester 9422 trigger job

Post by CamP »

I installed 17lb hammer springs in three different 9422's, and that gave my guns acceptable triggers. I used Wolff springs for Ruger Single Action Revolvers and cut about 1/2" off them to match the length of the original spring. The springs are very hard and I used a special heavy duty wire cutter for this job.
Post Reply