.32 H&R Magnum / .327 Federal for Pistol Cartridge?
-
Jetmugg
- AAA Poster

- Posts: 568
- Joined: Tue Dec 06, 2005 10:10 pm
- Location: Festus, MO
Re: .32 H&R Magnum / .327 Federal for Pistol Cartridge?
No updates yet on my .327 Magnum results. The rifle is still sitting in my gun safe, unfired. I have installed a Williams rear sight, and also have a set of scope bases to be used when ammo testing at some point.
Yesterday was the first day I was able to get out to the local club to sight-in and sort out any rifles for the upcoming silhouette season which starts on March 15th.
Hopefully, yesterday was only the first of many such days. I have a couple of new rifles to sort out, and I probably spend too much time messing around with different sighting setups, trying to find the best combination of components.
Yesterday was the first day I was able to get out to the local club to sight-in and sort out any rifles for the upcoming silhouette season which starts on March 15th.
Hopefully, yesterday was only the first of many such days. I have a couple of new rifles to sort out, and I probably spend too much time messing around with different sighting setups, trying to find the best combination of components.
-
chicknsnipr60
- Unclassified Poster
- Posts: 7
- Joined: Sun Dec 07, 2014 8:31 pm
Re: .32 H&R Magnum / .327 Federal for Pistol Cartridge?
Took my 327mag out last Wednesday and was well pleased. Loaded two loads 5.0 and 5.5 titegroup.Got speeds 1655 to 1700 with no recoil. Bottomed out was shooting over chickens. Shot the pigs and was dead on with hits on top of each other on a swinger. Shot the ram with same setting and had a dead center hit. spread was 48 and had a dev of 14. Going to change front sight and put it on paper.
-
Jetmugg
- AAA Poster

- Posts: 568
- Joined: Tue Dec 06, 2005 10:10 pm
- Location: Festus, MO
Re: .32 H&R Magnum / .327 Federal for Pistol Cartridge?
Thank you for the report, Chickensniper for the report. Your results are definitely encouraging. Also - BIG THANKS for sharing your load data. My .327 is still sitting in the safe in unfired condition, but that should change pretty quickly. The first Pistol Cartridge lever action match is April 12th. I will most likely shoot my existing .22 WMR rifle in that match, but hope to shoot the .327 this weekend with some factory loaded ammo to get an initial break-in and sight settings.
Thanks again,
steve.
Thanks again,
steve.
-
Jetmugg
- AAA Poster

- Posts: 568
- Joined: Tue Dec 06, 2005 10:10 pm
- Location: Festus, MO
Re: .32 H&R Magnum / .327 Federal for Pistol Cartridge?
chicknsnipr60 wrote: Fri Mar 27, 2026 6:26 pm Took my 327mag out last Wednesday and was well pleased. Loaded two loads 5.0 and 5.5 titegroup.Got speeds 1655 to 1700 with no recoil. Bottomed out was shooting over chickens. Shot the pigs and was dead on with hits on top of each other on a swinger. Shot the ram with same setting and had a dead center hit. spread was 48 and had a dev of 14. Going to change front sight and put it on paper.
Oooh - one more question if you are willing to share: Which bullet offering are you using with those loads? 80 grains, 95 grains, something else entirely?