Can anyone give me, or direct me, to some files to cut out silhouette stencils. My machine (Silhouette Cameo) can import .studio, .gsd, .dxf, .png, .jpg, .jpeg, .gif, .tif, .tiff, and .bmp. I have found some things but it just ain't right 100%.

Thanks a bunch

This thread on RFC might give you a few leads...

http://www.rimfirecentral.com/forums/sh ... p?t=595229

Ok, that did not work so I went to work. Several hours later I have workable files for my Cameo.

Ended up scanning free .pdf targets to a .tif. open the .tif and use the trace tool. Rams were a lot of work to get the hole for the horns.

Hey wherdthatunhit,
I sent you a PM with dxf files of the smallbore animals. Don't know how often you check pm's.

ShootingStar

Thank you ShootingStar. I got busy and forgot all about it, but again, thank you. I was over in Knoxville this summer and almost had some time off to go to a match or two. i was going to go to Asheville or Chattanooga. Might still get there some time. Did you see the picture of my cup I posted?