Page 1 of 1
How tight for bolt shroud on an Anschutz 1710 hb
Posted: Tue Sep 10, 2013 8:31 am
by p5200
I installed a J&P Striker spring kit and was wondering if the shroud should be screwed back on just til it's snug or, as tight as I can get it using my fingers? Thanks!
Re: How tight for bolt shroud on an Anschutz 1710 hb
Posted: Tue Sep 10, 2013 10:38 am
by Bob259
p5200 wrote:I installed a J&P Striker spring kit and was wondering if the shroud should be screwed back on just til it's snug or, as tight as I can get it using my fingers? Thanks!
On my 54 action I just snugged it up so it was tight, I would not try to over tighten it, snug enough so it won't loosen is fine.
Re: How tight for bolt shroud on an Anschutz 1710 hb
Posted: Tue Sep 10, 2013 3:15 pm
by p5200
Maybe I'd better loosen mine a little and re tighten it with a little less torque. Thanks!