Sights for Remington 572 pump
-
Varn
- A Poster
- Posts: 205
- Joined: Sat Aug 12, 2006 9:46 pm
Sights for Remington 572 pump
I am considering buying a Remington 572 for cowboy silhouette. Has anyone ever used one of these and if so could they recommend a set of sights for me? I was thinking of trying the Williams FP sight that attaches to the dovetail to avoid having to drill and tap the receiver. Any experience with these sights? Thank you. Mark
-
glen ring
- Master Poster
- Posts: 1084
- Joined: Wed Oct 25, 2006 3:04 pm
Re: Sights for Remington 572 pump
Mark
My wife shoots a Remington 572 and they're a neat little gun. The stock on the BDL seems to high for iron sights and you may need to get a 572 fieldmaster rear stock, or bring it into572 fieldmaster dimensions. I was also told by Remington that it's the same rear stock on a 20 guage 870. The 572 field master has a low enough stock to comfortably use iron sights. We left the front sight on as it's attached to the barrel by two screws, but took off the rear sight . We called Williams and they recommended the low 5D. This sight just clamps on the grooves where the scope would clamp. We had a trigger job done on the gun and it seems to like standard velocity rounds, especially CCI.
My wife shoots a Remington 572 and they're a neat little gun. The stock on the BDL seems to high for iron sights and you may need to get a 572 fieldmaster rear stock, or bring it into572 fieldmaster dimensions. I was also told by Remington that it's the same rear stock on a 20 guage 870. The 572 field master has a low enough stock to comfortably use iron sights. We left the front sight on as it's attached to the barrel by two screws, but took off the rear sight . We called Williams and they recommended the low 5D. This sight just clamps on the grooves where the scope would clamp. We had a trigger job done on the gun and it seems to like standard velocity rounds, especially CCI.
Just Be Nice 
-
glen ring
- Master Poster
- Posts: 1084
- Joined: Wed Oct 25, 2006 3:04 pm